Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Fast, Reliable Gate Installation Across The Acreage
A new driveway gate in The Acreage typically runs between $4,800 and $9,500 installed, depending on whether you’re replacing an existing gate or starting from bare posts, the length of the panel, and the operator you choose. Most Gate Installation projects in this part of western Palm Beach County take two to four days from footing excavation to final programming. We schedule a free on-site measure, hand you a written price before any work starts, and send a background-checked technician who already knows what The Acreage’s soil does to gate posts. Call (561) 725-8048 and a live person answers.
Why Vance Gate Repair West Palm Beach Is The Acreage’s Preferred Gate Installation Company
The Acreage is unlike every other community we work in. Lots are an acre and a quarter, minimum. Driveways run long off dirt and shell-rock roads. And the ground underneath moves with the water table. We know this because we’ve pulled posts out of that muck and seen what happens when a footing was poured too shallow. When we set a post in The Acreage, we over-excavate the hole, go deeper than standard, and spec hardware that won’t corrode in seasonal standing water. That’s the difference between a gate that still opens cleanly in year eight and one that binds on the latch by year three.
Adrian Vance built this company on commercial access-control documentation, and that habit carries into every residential job we do here. You get a written scope, a written price, and a photo record of what was installed and how it was set. No guesswork for the next technician. No paying twice to rediscover the same problem. That’s the Haven Standard, and it applies to every gate we install in The Acreage, from a single swing panel on 140th Avenue to a double gate on a five-acre equestrian property off Orange Boulevard.
Our Gate Installation Services in The Acreage

Driveway Gate
The Acreage’s private driveways mean every installation is a one-off. We build driveway gates to the width of your entrance, the weight of your panel, and the wind load your side of the community actually gets. Most homeowners here want a gate that lets delivery trucks in without the driver walking a quarter mile to the house. We program keypads, remotes, and phone-based entry so the gate opens from inside the truck, not outside it. Typical driveway gate installation in The Acreage runs $5,500 to $9,000 with operator.

Pedestrian Gate
Plenty of The Acreage properties have a separate walk gate next to the main driveway entrance, often because the driveway gate is too heavy to cycle open for every visitor on foot. A pedestrian gate with a magnetic lock or keypad entry runs $1,800 to $3,400 installed. The soil work is smaller, but the same rule applies: over-excavate and set deeper than code. A leaning walk gate on a muck footing jams in the first wet season.

Sliding Gate
Sliding gates make sense on long, flat driveway runs where a swing panel would eat too much frontage. In The Acreage, the catch is the soil under the track. If your lot sits near one of the community’s drainage swales, the ground floods in summer and the bottom rollers sit in water. We spec stainless or hot-dip galvanized track components and set the operator on an elevated pad. A properly built sliding gate installation here runs $6,200 to $11,000 including operator, vehicle loop, and safety photo-eyes.

Swing Gate
Swing gates are the dominant style in The Acreage, especially for equestrian properties with heavy tubular-steel or aluminum ranch panels. The failure point is almost never the panel. It’s the posts. When the hinge post leans even two degrees, the latch side binds and the operator strains until a limit switch fails. We core out old footings, set 6×6 galvanized posts four feet deep in concrete with stainless anchor bolts, and pair the panel to an operator sized for the actual weight. Swing gate installation in The Acreage runs $4,800 to $8,500 for a single, $9,000 to $15,000 for a double.

What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Before
AfterTrusted Brands We Service in The Acreage
We work on all nine major gate-automation brands, so you’re never steered toward replacing a motor we’d rather not repair. For new installations in The Acreage, we commonly spec Viking, Ghost Controls, and DoorKing operators, matched to the weight and duty cycle of the specific panel. Elite tubular-steel gates come up regularly on equestrian properties, and we weld and fit them on site. Parts for these brands are stocked in our South Florida warehouse, so a board replacement or a new arm doesn’t mean a two-week wait. You get the right operator for a muck-soil, lightning-heavy lot, not whatever happens to be on the truck.
Common Gate Installation Problems We See in The Acreage Homes

- Post lean from heaving muck soil. The organic fill under much of The Acreage expands and contracts with the water table. Shallow footings lift in wet months, tilting hinge posts and binding the gate on the latch side. We over-excavate and go four feet deep minimum, because resetting a leaned post costs more than digging it right the first time.
- Bottom hardware corrosion on swale lots. Properties along the low-lying drainage swales that cross the community’s shell-rock roads see standing water at the gate line every summer. Zinc-plated rollers and weld joints fail in under five years. We spec stainless and hot-dip galvanized from the start.
- Control board failures from lightning. Daily summer thunderstorms hit western Palm Beach County hard, and gate boards don’t survive direct or even near strikes. Every installation we sell in The Acreage includes a surge suppressor on the operator and the loop detector. It’s a $150 part that saves an $800 board.
- Undersized operators on heavy equestrian gates. Many older The Acreage properties still run 15 to 25-year-old Linear or early LiftMaster slide-gate kits spec’d for a light residential panel, not a 400-pound tubular-steel ranch gate. The operator works itself to death. We size new operators by measured panel weight, not by guesswork.
Pricing for Gate Installation in The Acreage, FL
Here are the real numbers for The Acreage’s market, as of this year:
| Service | Typical Range |
|---|---|
| Single swing gate with operator | $4,800 - $8,500 |
| Double swing gate with operator | $9,000 - $15,000 |
| Sliding gate with track, operator, vehicle loop | $6,200 - $11,000 |
| Pedestrian gate with keypad | $1,800 - $3,400 |
| Post footing replacement (each post, incl. excavation) | $650 - $1,100 |
What moves the price: gate length and material, whether we’re reusing an existing operator, the depth of the footing work your specific lot requires, and whether you’re near a swale that demands upgraded stainless hardware. Every quote is written, itemized, and handed to you before any tool comes off the truck. That’s Clause 1 of the Haven Standard, and it applies to every project, no exceptions. Call (561) 725-8048 for a free on-site estimate.
We Also Serve Cities Near The Acreage

Our installation crews in The Acreage also handle gate projects in The Acreage‘s neighboring communities, including West Palm Beach, Westgate, Riviera Beach, and Lake Park. If your property sits just outside the community boundary, call (561) 725-8048 and we’ll confirm coverage for your address on the spot.
Serving The Acreage, FL - Our Local Coverage Area
We’re based in the The Acreage area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs - Gate Installation in The Acreage

Gate posts in The Acreage should be set a minimum of 36 to 48 inches deep, with the hole over-excavated wider than the post and backfilled with concrete, not native soil. The organic muck and sandy fill common across western Palm Beach County heave with the seasonal water table, and anything shallower than three feet will lean within a few wet seasons. On swale-adjacent lots or heavy double-gate installations, we spec helical piers driven below the muck line. Get an exact post specification for your lot by calling (561) 725-8048.
Yes. If your The Acreage lot sits along one of the community’s low-lying drainage swales, your gate’s bottom rollers, hinge brackets, and weld joints will sit in standing water during the summer wet season. Zinc-plated hardware corrodes and fails in under five years. We spec stainless steel or hot-dip galvanized components on every swale-adjacent installation, and we photograph every piece before it goes in so the record is there for the next technician. Call (561) 725-8048 for a swale-specific hardware quote.
Your control board failed because lightning from one of The Acreage’s daily summer thunderstorms hit the gate, the fence line, or the ground nearby, and the surge traveled into the operator through the power line or the vehicle loop. This is the single most common operator failure we see in The Acreage between June and September. The fix is a surge suppressor on both the AC input and the loop detector, installed at the operator. We include surge protection on every new installation and retrofit it on service calls for about $150. Call (561) 725-8048 to schedule a board replacement with surge protection.
A heavy tubular-steel equestrian swing gate in The Acreage typically needs an operator rated for at least 400 to 600 pounds of panel weight and 16 to 20 feet of leaf length, which puts you in the LA500 or equivalent class rather than a residential kit operator. Older properties often have undersized Linear or early LiftMaster units that were never spec’d for the panel they’re pushing. We weigh the gate on site, measure the hinge geometry, and match the operator to the actual load. Call (561) 725-8048 for a written size calculation before you buy anything.
Yes, and it’s a common request in The Acreage, where gate lines can run hundreds of feet from the house and trenching power out to the operator gets expensive fast. We install solar-powered operators from brands like Ghost Controls and Viking, sized to the panel weight and paired with a battery bank large enough to ride through cloudy stretches and the short winter days. The panel mounts on an adjustable post, and we run the numbers on your specific duty cycle before recommending it. Call (561) 725-8048 and we’ll walk the site with you.
Need a written price for a new gate in The Acreage? Call (561) 725-8048. A live person answers, any hour, and your estimate is free with no obligation. We’ll schedule a site measure, spec the posts for your soil, size the operator for your panel, and hand you the number before anything gets built.
Written by Adrian Vance, Owner at Vance Gate Repair West Palm Beach.





Before
After
Before
After